TARGET_IS_TM4C129_RA2 configuration

Hiroyasu Tazawa1

Other Parts Discussed in Thread: TM4C1294KCPDT

Hi, Everyone

I need your help.
I use TM4C1294KCPDT sillicon rev3.

I think we should use TARGET_IS_TM4C129_RA2 on Pre-defined Symbol of CCS.
but I have some error when I get this configuration.
because I think Tivaware does not support TARGET_IS_TM4C129_RA2.
rom.h does not have this define.

Tivaware support TARGET_IS_TM4C129_RA2?
What should we do??

Best Regards
Hiroyasu

over 10 years ago

0 Amit Ashara over 10 years ago

TI__Guru**** 244400 points

Hello Hiroyasu,

Please use TARGET_IS_TM4C129_RA1. The ron.h contents are same for RA1 and RA2

Regards
Amit

0 Hiroyasu Tazawa1 over 10 years ago in reply to Amit Ashara

Guru 12350 points

Hi,Amit

Thank you for your reply.
I use TARGET_IS_TM4C129_RA1 on TM4C129x Sillicon rev3.

Best Regards
Hiroyasu

0 Hiroyasu Tazawa1 over 10 years ago in reply to Hiroyasu Tazawa1

Guru 12350 points

Hi Amit

I want to make sure about TM4C123x too.
I understand we should use TARGET_IS_BLIZZARD_RB1 on TM4C123x Silicon revision 6/7
Is it correct??

Regards
Hiroyasu

0 Amit Ashara over 10 years ago in reply to Hiroyasu Tazawa1

TI__Guru**** 244400 points

Hello Hiroyasu,

Yes for the moment RB1 should be used for both Rev 6 and 7

Regards
Amit

0 Hiroyasu Tazawa1 over 10 years ago in reply to Amit Ashara

Guru 12350 points

Hi Amit

Thank you!
I appreciate to you.

Regards
Hiroyasu

Arm-based microcontrollers

Arm-based microcontrollers forum

TARGET_IS_TM4C129_RA2 configuration