Code Composer Studio

GUNTOJU ANAND KUMAR

I am Using CCS5.4 and i executed the example code provided by TI .I gave 3V from power supply and output is seen in Putty.The converted value is stored in conversion result bits in ADCFIFO but digital value is not updated in FIFO.

over 10 years ago

0 Amit Ashara over 10 years ago

TI__Guru**** 244440 points

Hello Guntoju,

I understand the ADCFIFO. What do you "exactly", mean by the digital value is not updated in FIFO?

Regards
Amit

0 GUNTOJU ANAND KUMAR over 10 years ago in reply to Amit Ashara

Intellectual 340 points

Hello Amit Sir
if my input from power supply is 1.3v.then the conversion result bits should be changed right?

0 Amit Ashara over 10 years ago in reply to GUNTOJU ANAND KUMAR

TI__Guru**** 244440 points

Hello Guntoju,

I am not clear as to what you have just mentioned. Do you mean that when the Analog Channel is connected to 1.3V then the ADC should show the code corresponding to 1.3V (based on what ADC Voltage ref has been used). if that is the case then yes. But do make sure that the Pin is configure for Analog Function.

Regards
Amit

Arm-based microcontrollers

Arm-based microcontrollers forum

Code Composer Studio