TI RTOS Hwi Event ID

Hi

DataSheet chapter 2 "the Cortex-M4F Processor" page 116 about.

Here is the "Interrupt number" of HWI corresponding to "Vector number" in the Data Sheet.

Regards

Thanks for the quick reply,

But what I actually need to know is when creating the Hwi can't we specifically say which type of UART interrupt
eg:- FIFO full , data received etc.
because when we use the interrupt number and specify the UART module Hwi is triggered for every kind of event.
As far as I understood the purpose of event id is to specifically select the type of interrupt. But my requirement is to interrupt for a UART receive only.

Hi,
Ok sorry my interpretation of your question.
Now I understood your question, but I can not help you, sorry.
I think you should send your question to the specific forum, "TI-RTOS" forum.

e2e.ti.com/.../tirtos

Regards

Hello Sahan,

The UART sends only one interrupt. It is the interrupt handlers responsibility to process the cause of the interrupt.

Regards
Amit