problem with SSI module

Rukmani Kavi

Prodigy 140 points

Shall i use normal SPI EEPROM(25C040), When I communicate with SSI master of tm4c. And then how to communicate it

over 11 years ago

0 Luis Afonso over 11 years ago

Guru 20670 points

Hi Rukmani,

I'm sorry but I'll have just to say: what?
I didn't understand a thing of what you are asking.

0 Amit Ashara over 11 years ago

TI__Guru**** 244440 points

Hello Rukmani,

What is "normal" SPI? Please check the protocol requirements v/s the SSI requirements. In all likelihood the use of GPIO as a CS will allow you to communicate TM4C with the EEPROM. However do make sure IO requirements in terms of voltage and mode/timing is compatible.

Regards
Amit

Arm-based microcontrollers

Arm-based microcontrollers forum

problem with SSI module