• State
  • Locked Locked
  • Replies 3 replies
  • Subscribers 31 subscribers
  • Views 421 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TM4C123GXL-No unused FET found

Likhitha Eugene James P
Expert 2270 points
Other Parts Discussed in Thread: ENERGIA

Hi,

Energia is used

When i flash the code i am getting the "No unused FET found" error

  • 0
    Guru 20670 points
    short question, so short answer, it's because no unused FET was connected to your computer.

    Slightly longer answer, you have selected a MSP430 based launchpad. Select TM4C123 launchpad. github.com/.../Getting-Started
  • 0 in reply to Luis Afonso
    Guru 20670 points
    Btw, for better support on Energia it's best to go to Energia Forum. The forum is located here: http://forum.43oh.com/
  • 0 in reply to Luis Afonso
    Guru 117855 points

    Luis Afonso said:
    Short question, so short answer

    Hi Luis,

    I've 2 issues w/your (otherwise) neat response, here:

    a) There was NO question - poster's writing was (admittedly) short - but in (only) declarative format.

    b) as she's new here - would it not make sense to "guide a bit" towards helpers' need for a (somewhat) tad considered, tech. request.

    As this vendor (fails) in poster guidance - it falls to we "helpers" to (endlessly) repeat proper poster protocol - to include proper post detailing.

    Today our group succeeded in drawing 120 Amps thru a real power "FET" - while remaining w/in both current & temperature ratings.   Vendors (unofficial) "reuse" of a common acronym "FET" may cause confusion.     I can't recall an encounter prior to your mention - here...