EK-TM4C1294XL for Production

Faizal Rezi

Prodigy 60 points

Other Parts Discussed in Thread: EK-TM4C1294XL

Hi,

Can I release my product using EK-TM4C1294XL for production?

Thank you,

Faizal Rezi

over 10 years ago

0 Chester Gillon over 10 years ago

Guru 92251 points

http://www.ti.com/tool/EK-TM4C1294XL states:

TI's Standard Terms and Conditions for Evaluation Modules apply.

Does the STANDARD TERMS AND CONDITIONS FOR EVALUATION MODULES answer your question?

0 Faizal Rezi over 10 years ago in reply to Chester Gillon

Prodigy 60 points

Yes, thank you.
So, how if I want to use it in my product?

0 Amit Ashara over 10 years ago

TI__Guru**** 244400 points

Hello Faizal,

You would need to redesign the base board for your application instead of using the EVM. As Chester mentioned it, TI is not liable for any productized version of the EVM's for any application....

Regards
Amit

0 Faizal Rezi over 10 years ago in reply to Amit Ashara

Prodigy 60 points

Whether there is an alternative board that can be used for production?

0 cb1_mobile over 10 years ago in reply to Faizal Rezi

Guru 117855 points

You may note that TI designed that board - yet (likely) assigned the pcb build & part procurement (other than the MCU) to (skilled) others. That's "normal/customary" in this industry - and may serve as a model or roadmap for you.

Board in question was primarily designed as a low-cost "learning platform" - even if you could use it - a custom board - designed to best meet your objectives - is likely to prove superior...

0 Amit Ashara over 10 years ago in reply to Faizal Rezi

TI__Guru**** 244400 points

Hello Faizal,

I would suggest checking a few vendors like below.

www.mikroe.com/.../mcu-cards

Regards
Amit

Arm-based microcontrollers

Arm-based microcontrollers forum

EK-TM4C1294XL for Production