how to program emac id to a fresh tm4c1294 chip?

mamatha g

Other Parts Discussed in Thread: TM4C1294NCPDT

I am working on a custom board containing tm4c1294ncpdt controller. I tried to test the ethernet portion using the sample code available from TI. But it is not working due to no mac ID. It gets hung at reading emac ID section of the code. I want to know how to program the MAC id to the chip.

over 10 years ago

0 mamatha g over 10 years ago

Intellectual 490 points

I am using another TIVA tm4c1294 launchpad as debugger. I couldnt use LM Flasher successfully. Let me know how to configure LM flasher for emac address flashing using the eval. bard as debugger.

0 Amit Ashara over 10 years ago

TI__Guru**** 244440 points

Hello Mamatha,

When using another LaunchPad as a programmer, how have you made the connection? Did you search the forum for references as surely I have put out a post in the past highlighting how to do the same.

Regards
Amit

Arm-based microcontrollers

Arm-based microcontrollers forum

how to program emac id to a fresh tm4c1294 chip?