Programming in RM48L952 for ADC

Manjunathan K

Other Parts Discussed in Thread: HALCOGEN

I have programmed to interface Analog output sensor modules through ADC1 in RM48. i got warning (#177-D subscript out of range). how to rectify it. what is the reason for this warning

over 10 years ago

0 KARTHIKEYAN RAJAMANICKAM over 10 years ago

TI__Genius 11645 points

Hi,

Can you give little more details on where you get this warning, so that I can have a look at it ?

0 Manjunathan K over 10 years ago in reply to KARTHIKEYAN RAJAMANICKAM

Expert 2825 points

if i try to interface two analog output sensors then there is no warning while building the project in CCS. if i enable more than two analog pins in ADC1 (halcogen) , then this warning popups as while rebuilding the project in CCS

0 Manjunathan K over 10 years ago in reply to KARTHIKEYAN RAJAMANICKAM

Expert 2825 points

Arm-based microcontrollers

Arm-based microcontrollers forum

Programming in RM48L952 for ADC