Program TM4C123GH6PGE Using TI DM8127

Akash Gajjar

Other Parts Discussed in Thread: TM4C123GH6PGE

Hi,

My production board contains TI DM 8127, Ti TM4C123GH6PGE Microcontroller and Steper motor driver chip to control stepper motor.

i want to program TM4C123GH6PGE, is there any way to do that except JTAG and i want to program directly using DM8127.

because its my production board and i don't want to program 100th of boards individual microcontroller by JTAG, if my soc is able to do that job.

regards

Akash Gajjar

over 9 years ago

0 Amit Ashara over 9 years ago

TI__Guru**** 244400 points

Hello Akash,

TM4C devices serial boot loaders over UART, I2C and SSI which can be used to flash the device. The upcoming Application note and the Boot Loader User Guide in TM4C would be good resources to start with.

Regards
Amit

0 Akash Gajjar over 9 years ago in reply to Amit Ashara

Intellectual 510 points

Thanks for your information..

0 Amit Ashara over 9 years ago in reply to Akash Gajjar

TI__Guru**** 244400 points

Hello Akash,

Do note that the there are other interfaces as well like USB and Ethernet (for TM4C129 only), but due to the nature of the boot loader on these interfaces the other 3 mentioned would be far simpler/

Regards
Amit

Arm-based microcontrollers

Arm-based microcontrollers forum

Program TM4C123GH6PGE Using TI DM8127