Ssi3 not working in tm4c1231 controller. Any body tried it , then please share.

Few (more) tags could not hurt...

Usually - but not always - if you've succeeded w/other SPI instantiations - your "failed" SPI may require, "special handling."    Check for MCU pins which require, "Unlocking, or special set-up/configuration, or which may be routed in ways detrimental to your use."  (i.e. tied to other MCU pins - to meet past (far lesser) MCU requirements.)

As always - the detail provided via, "Not Working" is useless to those seeking to assist.

Hello Yashpal,

And the code that is not working for SSI3? Also what is not working would be a useful information too:Bus fault, IO not toggling, etc!

Regards
Amit

Unless poster "f.m." was correct - it's hard to imagine how so much effort was directed into "tag listing" and ZERO into that which, "Does not work."

Since none of the tags appear to be related to the problem noted, the amount of directed thinking appears entirely consistent.

Robert

That's true - but (perhaps) outside of my comment - which noted "effort" expended in, "tag listing."