RM57 STC Halcogen

Akshay Immanuel

Other Parts Discussed in Thread: HALCOGEN

Halcogen for RM57 does not highlight the STC modules.
As a result im unable to generate the drivers for the STC modules.
How to get the STC Api's using Halcogen ?
The same applies for PBIST as well...Any driver Api's for PBIST also would be greatlt appreciated.

Thanks.

over 10 years ago

0 Anthony F. Seely over 10 years ago

TI__Guru 69070 points

Akshay,

Look for the STC code in the "SafeTI Diagnostic Library" that is installed with HalCoGen. If you install HalCoGen in C:\ti\Hercules, the library will be: C:\ti\Hercules\SafeTI Diagnostic Library

0 Akshay Immanuel over 10 years ago in reply to Anthony F. Seely

Expert 1160 points

I found the folder...but how to include that safety lib files? Must i open a demo app .hcg file and configure that as per my requirements?

0 Akshay Immanuel over 10 years ago in reply to Anthony F. Seely

Expert 1160 points

Also SPNA106D states the required initialization process for RM57...does the Halcogen generated code take care of this process for safety applications?

0 Anthony F. Seely over 10 years ago in reply to Akshay Immanuel

TI__Guru 69070 points

Akshay,

There is an 'example_SafetyLibrary' that ships with halcogen that gives you the general idea on how to integrate HalCoGen and the Safety Lib.

This is just demo code so you should do your own audit against what the initialization appnote says to do. It should get you started but I wouldn't just trust that it matches the documentation at this point -- still under development. There is a new safety lib release coming in mid april as well.

Did you have any other questions on this thread ?

Arm-based microcontrollers

Arm-based microcontrollers forum

RM57 STC Halcogen