error could not open source file "drivers/pinout.c" ,"drivers/frame.c" TM4C129XNCZAD

basawaraj talawar

Prodigy 210 points

Other Parts Discussed in Thread: TM4C129XNCZAD

i included the drivers but its showing the error

error could not open source file "drivers/pinout.c" ,"drivers/frame.c" TM4C129XNCZAD

please help me regarding this issue Thanks for ur help

over 10 years ago

0 Robert Adsett over 10 years ago

Guru 27665 points

Why are you not linking with the library?

Robert

0 Chuck Davenport over 10 years ago

TI__Guru 59540 points

Hello Basawaraj,

When you state that you included these files, how did you include them? In other words, did you add them to your project in CCS and also add them to the include path in the project setup? Or, did you only add them into the source files such as #include "xxxxx" . You will need to do both. If you added them to an already included INCLUDE directory, this should be ok. Also, can you check the #include statement in the source file to insure it has the correct path information?

0 Robert Adsett over 10 years ago in reply to Chuck Davenport

Guru 27665 points

Umm, using #include to bring in a source file would not be a good thing.

Robert

0 Chuck Davenport over 10 years ago in reply to Robert Adsett

TI__Guru 59540 points

Thanks Robert for the catch. Guess I read "include" in the topic and set down the wrong path.

With that in mind, I would suggest looking at the project to insure the file properties for the files in CCS are correctly pointing to the files. Generally, when you open a project, it will give an error if an included file is not found where CCS thinks it should be. Another option is to look at the compiler settings to make sure the directory is in the project path.

0 basawaraj talawar over 10 years ago in reply to Chuck Davenport

Prodigy 210 points

hi
i included drivers in both inclde directory and in source files again i m getting same error please help me

0 basawaraj talawar over 10 years ago in reply to basawaraj talawar

Prodigy 210 points

finally i successfully include the drivers by comparing with tiva launchpad project examples thanks for ur help

Arm-based microcontrollers

Arm-based microcontrollers forum

error could not open source file "drivers/pinout.c" ,"drivers/frame.c" TM4C129XNCZAD