Question about Kentec QVGA Display and ADC128S102EVM BoosterPacks

The 2 parts I'm asking about are:
BOOSTXL-K350QVG-S1 Kentec QVGA Display BoosterPack and
ADC128S102EVM

Hello Moataz

Yes, BOOSTXL-K350QVG-S1 is compatible with EK-TM4C123GXL LaunchPad. As for the ADC128S102VM, the SSI line are being shared with the Display Booster Pack. if the CS for the two boosterpacks are different then they can be used.

You may want to use

https://dev.ti.com/bpchecker/

Regards
Amit

Thanks for your replay,

This means that if I use only one boosterpack at a time, everything will be OK, right?

Hello Moataz,

Not necessary. If the two boosterpacks do not share a CS then it is possible to share the CLK, MOSI and MISO lines between the 2 boosterpacks. The only critical item that I can think of is while communication is ongoing with one boosterpack, an interrupt generated by the other should be delayed (typically a semaphore), for the communication to complete before the next is processed.

Regards
Amit

Hello,
I have a very simple application with only one boosterback at a time; only one boosterpack is attached to the EK-TM4C123GXL.
I just need to be sure that the EK-TM4C123GXL is compatible with both boosterbacks.
I'm not going to share the SPI bus betwwen them.

Hello Moataz

Then it should be fine. Do go through the schematics of the ADC128S102EVM to make sure it follows the booster pack standard as I have never used the same. The Display boosterpack works fine with the EK-TM4C123GXL as I have used it (and so have other forum members)

Regards
Amit