PinMux Utility Change Device

kohei watanabe

Prodigy 50 points

I need some advice for set up the PinMux Utility.

I had download the PinMux Utility V1.0.4 and installed.

However I can not fid the suitable device for EK-LM4F120XL in the device list.

Please advice.

Thank you.

over 10 years ago

0 Amit Ashara over 10 years ago

TI__Guru**** 244440 points

Hello Kohei,

Tiva Pin Mux Utility is no longer supported and is replaced by TI Pin Mux Utility. Also TM4C12x devices are the one's in production and there is no LM4F devices listed either. You can however use the equivalent TM4C123x device for the LM4F120.

You can use the data in the following post to find the equivalent TM4C123x device.

e2e.ti.com/.../271820

Regards
Amit

0 kohei watanabe over 10 years ago in reply to Amit Ashara

Prodigy 50 points

Hi! Amit,

Thank you for your information.
It seems your suggestion woud be helpful for me.

Thank you.
Kohei

0 Amit Ashara over 10 years ago in reply to kohei watanabe

TI__Guru**** 244440 points

Hello Kohei,

You should however note that LM4F devces are not in production. So eventually you may need to use TM4C123x devices.

Regards
Amit

Arm-based microcontrollers

Arm-based microcontrollers forum

PinMux Utility Change Device