Is Reset executed when I connect between CCS and TM4C1294x ?

Hiroyasu Tazawa1

Guru 12350 points

Other Parts Discussed in Thread: EK-TM4C1294XL

Hi,

I have a quetion.
I use EK-TM4C1294XL.
Is Reset executed when I connect between CCS and TM4C1294x ?

I did this operation without Gel on C/C++ perspective.

View → Target Configuration →　Launch Selected Configuration
→ Connect on debug perspective

Do you have any answer ?

Best Regards
Hiroyasu

over 9 years ago

0 Amit Ashara over 9 years ago

TI__Guru**** 244440 points

Hello Hiroyasu,

There is an option in CCS where for a debug configuration you may connect to the device w/o issuing a reset to the TM4C12x devices.

Regards
Amit

0 Hiroyasu Tazawa1 over 9 years ago in reply to Amit Ashara

Guru 12350 points

Hi, Amit

Thank you for your reply,
and Can you tell me how to set on CCS Option you say ?

Best Regards
Hiroyasu

0 Amit Ashara over 9 years ago in reply to Hiroyasu Tazawa1

TI__Guru**** 244440 points

Hello Hiroyasu,

Select the Debug Configuration ccxml file, Right Click -> Properties

Program/Memory Load Options -> Connection Options

Uncheck "reset the target on a connect"

Regards
Amit

0 Hiroyasu Tazawa1 over 9 years ago in reply to Amit Ashara

Guru 12350 points

Hi, Amit

Thank you for your reply.

Igot it.

best regards

Hiroyasu

0 Amit Ashara over 9 years ago in reply to Hiroyasu Tazawa1

TI__Guru**** 244440 points

Hello Hiroyasu,

Please do check and confirm the procedure. I always use the above procedure when debugging a running program that may have crashed so as to not affect the state of the device.

Regards,
Amit.

0 Hiroyasu Tazawa1 over 9 years ago in reply to Amit Ashara

Guru 12350 points

Hi, Amit

O.K. Thank you, Amit

Best Regards
Hiroyasu

Arm-based microcontrollers

Arm-based microcontrollers forum

Is Reset executed when I connect between CCS and TM4C1294x ?