Load HEX file with CCS and XDS200

Gregory Holcomb

Other Parts Discussed in Thread: UNIFLASH

My development system is the Keil compiler using Tivaware and my jtag debugger is a Keil Ulink2. TI processor is TM4C129EN. I've developed an application and now need my technician to load the generated HEX file into a number of assemblies. My technician has access to only CCS and a Spectrum Digital XDS200 jtag debugger. Are there instructions anywhere on how to go about that?

over 10 years ago

0 Sai Reddy over 10 years ago

TI__Mastermind 22640 points

Hello Gregory,

Did you already look at XDS200's home page here: www.ti.com/.../TMDSEMU200-U

Does it not answer your question? If not can you explain what exactly you are having trouble with?

Thanks,
Sai

0 Gregory Holcomb over 10 years ago in reply to Sai Reddy

Prodigy 50 points

I seem to be all set. The XDS200 home page pretty clearly states that CCS must be used with a XDS200, but, a coworker mentioned UniFlash and it turns out UniFlash can accept HEX files and is compatible with XDS200 as well.

Arm-based microcontrollers

Arm-based microcontrollers forum

Load HEX file with CCS and XDS200