Oscillator for RM48L952DZWTT

Dmitri Chtchvyrkov

Prodigy 130 points

If an external oscillator is used (not a crystal), shall its GND pin be connected to a signal ground or Kelvin GND pin?

Thank you.

over 9 years ago

0 Anthony F. Seely over 9 years ago

TI__Guru 68920 points

Hi Dmitri,

In this case I think you can use the board ground. The waveform should be high amplitude and the edge rate should be fast, right? It's not sinusoidal like the OSC...

0 Dmitri Chtchvyrkov over 9 years ago in reply to Anthony F. Seely

Prodigy 130 points

Dear Anthony,
Thank you very much for your help.
Regards,
Dmitri

Arm-based microcontrollers

Arm-based microcontrollers forum

Oscillator for RM48L952DZWTT