Hercules ControlCard TMDX570LS12CNCD XDS100v2 Error

Tibor

Prodigy 140 points

Hi All,

Download via the on-board XDS100V2 fails with the following message:

ComPort: Can't Initialize Target CPU: The driver property "Endianness" was not defined

I was unable to find any reference to this problem.

JTAG test returns with pass.

Regards,

Tibor

over 9 years ago

0 Bob Crosby over 9 years ago

TI__Guru 72500 points

Which version of CCS are you using?

0 Tibor over 9 years ago in reply to Bob Crosby

Prodigy 140 points

Hi Bob,

I'm using version 6.1.2

Regards,

Tibor

0 Bob Crosby over 9 years ago in reply to Tibor

TI__Guru 72500 points

OK, yesterday I checked it using v6.1.3 which is on my machine and it worked fine. I will see if I can find a PC with 6.1.2 and check again.

0 Tibor over 9 years ago in reply to Bob Crosby

Prodigy 140 points

Hi Bob,

I've managed to resolve this issue.
I've removed the Uart port under the "Alternate communication" section within the Target configuration setting. Now I'm able to run the code in debug mode.
Thanks for your effort anyway.

Regards,
Tibor

Arm-based microcontrollers

Arm-based microcontrollers forum

Hercules ControlCard TMDX570LS12CNCD XDS100v2 Error