Hello.
I' m want download image.bin by UART via Serial Boot.
I'm read Serial Flash Downloader in SW-DK-TM4C123G-UG
Example:
The following will download a firmware image to the board over COM2 without auto-baud support:
sflash -c 2 -d image.bin
I had to 3 Step Sequence but image.bin not be downloaded.
Please check in attached picture.
What should I do ?
thanks
[1 STEP] Flash Erase Only, Erase Select
Blank Check After Erase , Complete
[2 STEP] Serial_boot_bin Download, ICDI interface
Download Complete
[3 STEP ] Hello.bin Download by sflash Dos Mode ( 0x1000 , 1000, 4096 Address 3 type, try) Error !!
Try to UART Interface of LM Flash Programmer,
