Components for FlexrayCANLin expansion Board

Markus Stamm

Hi,

I am ordering parts for the FlexrayCANLin expansion board for the HDK but there are some parts I am not able to find/figure out. Could anyone here help with that?

The parts are:

L1 - DROSSEL I-COMP (I cant find the correct size of this and I am not completely sure what it is)

SB1-SB16 / SB2 - I dont know at all what this is, maybe something with socket 0603?

Link to expansion board:

processors.wiki.ti.com/.../HDK_FlexrayCanLin_Daughter_Crad.zip

Thank you.

over 8 years ago

0 Charles Tsai over 8 years ago

TI__Guru**** 191736 points

HI Markus,
We have received your post and will get back with you.

0 Bob Crosby over 8 years ago in reply to Charles Tsai

TI__Guru 72500 points

L1 is an EPCOS (now TDK) B82720A2202N40. It is a 1.1mH 2 line common mode choke. Link. SB1 - SB16 are "solder bridges", just pads that you can solder a 0 Ohm resistor to if you want to connect that particular signal.

0 Markus Stamm over 8 years ago in reply to Bob Crosby

Prodigy 175 points

Thank you Bob,

I realized that I also am missing the J3 80-pin connector and the J7, do you possibly have any information about these also?

Best regards
Markus

0 Bob Crosby over 8 years ago in reply to Markus Stamm

TI__Guru 72500 points

Not sure of the exact part number, but iJ3 is an 80-pin 2mm header like LINK.

0 Bob Crosby over 8 years ago in reply to Bob Crosby

TI__Guru 72500 points

Checking to find J7.

Arm-based microcontrollers

Arm-based microcontrollers forum

Components for FlexrayCANLin expansion Board