Can we use Segger J link to debug TMC1294ENCPDT?

Sarvesh Pimpalkar24

Other Parts Discussed in Thread: SEGGER

I have a custom application based on TMC1294ENCPDT.

Can we use Segger J link debugger for debugging?

If yes, I would like to know the steps.

Any help regarding this would be highly appreciated.

Regards.

over 8 years ago

0 Amit Ashara over 8 years ago

TI__Guru**** 244400 points

Hello Sarvesh

Yes, you can use it but AFAIK with IAR EWARM studio.

0 Robert Adsett over 8 years ago in reply to Amit Ashara

Guru 27665 points

Segger supported IDEs (a few more than just IAR¹)

www.segger.com/jlink-ide-integration.html

Robert

1 - Which, of course, is one of the reasons for choosing a third party device.

0 cb1 over 8 years ago in reply to Robert Adsett

Guru 47900 points

In support of poster (friend) Robert's writing - indeed our small firm has used multiple J-Links with ARM MCUs from multiple vendors under the IAR IDE. We have succeeded w/this vendor's LM3S, LX4F and now TM4C123. (we avoid the device you mention as we find it (well) behind the Cortex M4 curve...)

Arm-based microcontrollers

Arm-based microcontrollers forum

Can we use Segger J link to debug TMC1294ENCPDT?