TM4C1294NCPDT: Tools to Program HEX into target

Ping Wang

Part Number: TM4C1294NCPDT
Other Parts Discussed in Thread: UNIFLASH

Dear all

I need some guide for tools to program HEX file into my target board intended for factory progarmming. The HEX is custom hex format include bootloader, Application and CRC generated/linked by a custom application.

Ideally use same interface as standard JTAG, I use XDS100v2 for debug.

Any advice please?

Regards!

Ping

over 8 years ago

0 Bruno Saraiva over 8 years ago

Guru 13040 points

Hello,
Uniflash will do the trick.
www.ti.com/.../UNIFLASH
For a more elaborated scenario, you could actually use the ROM bootloader, programming you new chips via serial port instead of JTAG: you could use a launchpad with a dedicated program, which detects the presence of a target on the serial line or some sort of sensing GPIO; when detected, starts a UART transfer to your new board kind of automatically and with no need for a PC.
Regards
Bruno

0 Ping Wang over 8 years ago in reply to Bruno Saraiva

Intellectual 330 points

Thanks you, Bruno!

Arm-based microcontrollers

Arm-based microcontrollers forum

TM4C1294NCPDT: Tools to Program HEX into target