CCS/TM4C1294NCPDT: tm4c1294ncpdt

kota rajesh

Tool/software: Code Composer Studio

HI,

Thanks for helping i wrote two timers one with 200 msec and another one with 1 min both timers are calling and working properly ,is their any tool for to analyze the timers.

Thanks

Rajesh .K

over 8 years ago

0 Bob Crosby over 8 years ago

TI__Guru 72500 points

I do not know of any tools specific to the timers. There are hooks in CCS for analyzing execution times. What type of analysis do you want to do on the timers?

0 kota rajesh over 8 years ago in reply to Bob Crosby

Intellectual 490 points

HI ,

Thanks for help

i am running to timers how i can forum i am getting HWI in every 200ms .....any gui or any analytics or any diagnostic tool available for that .

thanks
Rajesh.K

0 Bob Crosby over 8 years ago in reply to kota rajesh

TI__Guru 72500 points

The simplest way to check this is to toggle a GPIO pin in your interrupt routine and measure the time between toggles on an oscilloscope. If you have a digital scope, you can set the persistence to infinite and see the variation caused by the timer interrupt routine being blocked by other interrupt routines (if any).

Arm-based microcontrollers

Arm-based microcontrollers forum

CCS/TM4C1294NCPDT: tm4c1294ncpdt