BOOSTXL-SENSHUB: replacing for BOOSTXL-SENSHUB (MPU-9250 is NRND)

Vladimir Aparin

Part Number: BOOSTXL-SENSHUB

Hello,

I really like a BOOSTXL-SENSHUB based on MPU-9250. And was planned to use this sensor in my device.
But TDK/Invensense not recommend this p/n for design now and proposing ICM-20948 www.invensense.com/.../ as recommended replacement.
Does TI plane redesign BOOSTXL-SENSHUB on new ICM-20948?

Best regards, Vladimir

over 8 years ago

0 Vladimir Aparin over 8 years ago

Expert 2610 points

p.s. It's need to be pointed, that these devices is pin2pin compatible, but register is not.
TDK offer development boards from ST and Atmel - EV_INV-ARM и NUCLEO-F411RE. But I want to use TI MCU as you understand.

0 Charles Tsai over 8 years ago in reply to Vladimir Aparin

TI__Guru**** 191886 points

Hi Vladimir,
Thank you for choosing TI products. I doubt there will be any change to the boosterpack in the short term but I will double check.

Arm-based microcontrollers

Arm-based microcontrollers forum

BOOSTXL-SENSHUB: replacing for BOOSTXL-SENSHUB (MPU-9250 is NRND)