• State TI Thinks Resolved
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 32 subscribers
  • Views 1091 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LAUNCHXL2-570LC43: BoosterPack header with CAN bus transceivers

Mark Iennaco
Prodigy 20 points

Part Number: LAUNCHXL2-570LC43

I need actual CAN bus signal levels from the Hercules TMS570LC43x LaunchPad Development Kit.

Is there a BoosterPack header with CAN bus transceivers available?

I only need 1 can bus at a minimum, though 2 would be nice.

  • 0
    Expert 1995 points
    I am not with TI, but I think you would need a HDK to get that (not a LaunchXL2).
  • 0 in reply to NeilBerry_at_Parker
    Prodigy 20 points

    I'm aware that the HDK has the CAN transceivers built in.

    We are running mass tests on the Hercules with CAN and we routinely  exhaust the flash write cycles, so we have to replace the boards.

    The LAUNCHXL2-570LC43 is about 10% of the price of the HDK (29.99 vs 299.00) so it would be a big money saver if we could use the LAUNCH pad.

    But we need a real CAN bus interface.

  • 0 in reply to Mark Iennaco
    Expert 1995 points

    I pursued the same line of thinking with a RM46 Launchpad about a year ago. Obviously, you could use the Launchpad and HDK as a basis for a full custom board (which is what TI is likely to suggest that you do). The Launchpad might possibly be custom wired to expose the can lines and then mated, with clocking, to a transceiver on a CAN interface test jig.  It is not something I could say for sure would work.

  • 0
    TI__Guru**** 201416 points
    Hi Mark,

    The boosterpack header (J2) has 1 CAN (can4). The other CAN signals are on the dege connectors (J9 and J10). I am sorry that we don't have boostpack for the launchpad.