• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 30 subscribers
  • Views 328 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TM4C129DNCPDT: TM4C129DNCPDT

Constantin Roat
Prodigy 10 points
Part Number: TM4C129DNCPDT

In TM4C129DNCPDT Data Sheet, Ethernet Controller module, MII Interface Signals, EN0TXER signal is allocated to PN6 (port N bit 6).

But TM4C129DNCPDT port N has only bit 0 to 5 as pin out.

There is an other signal allocated for EN0TXER? Or?

Thank you 

  • 0
    TI__Guru**** 183226 points
    Hi,
    In this package (PDT) the EN0TXER is unavailable. This signal is only available in the BGA package variant. In the package that does not have the TX_ER signal, the MAC will provide a corrupt packet so that the downstream device will discard the packet. Therefore, the connected phy will not need the TX_ER input.