• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 31 subscribers
  • Views 274 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TM4C123BH6ZRB: BOOTCFG register: Use of Ports > Port H possible?

Tobi
Intellectual 320 points

Part Number: TM4C123BH6ZRB

Hello,

TM4C123BH6ZRB datasheet intro of BOOTCFG says: '...by using any GPIO signal from Ports A-Q as configured by the bits in this Register.'

But in register description "PORT" of BOOTCFG Register only 3 bits are intended!

Am I able to use port "Q" for BOOTCFG function? I'm afraid not...

Thanks in advance,

Tobi

  • 0
    TI__Guru 72500 points
    You are correct. There is a typographical error in this datasheet. Only ports A through H are supported for boot loader configuration. I have made a record of the error for future correction. Thank you for bringing this to our attention.