TM4C1294NCPDT: LM flash programmer error

Arun PK84

Part Number: TM4C1294NCPDT

Hi,

Am using LMflash programmer for programming TM4C129NCPDT controller.But during programming i am getting connectivity issue.

It is showing "unable to connect to target".If i try multiple times intermittently it is getting connected.Please support to solve this issue.

over 6 years ago

0 Ralph Jacobi over 6 years ago

TI__Guru*** 135355 points

Hello Arun,

Are you using custom hardware? If so, can you give details on the debugger used and how the JTAG schematic is setup?

Also, do you have any better behavior with CCS instead?

0 Ralph Jacobi over 6 years ago

TI__Guru*** 135355 points

Hello Arun,

I haven't heard back from you regarding my prior questions, so I’m assuming you were able to resolve your issue.

I will close this thread now, but if you have not solved this issue then post a reply below (or open a new thread if the thread has locked due to time-out).

Arm-based microcontrollers

Arm-based microcontrollers forum

TM4C1294NCPDT: LM flash programmer error