RM44L920: How to configure CRC program？

Kai Huang2

Part Number: RM44L920

Now I am working on the CRC program. My chip is RM44L920. I looked up a lot information,but I didn't find a routine for the CRC program.

I look forward to helping me configure CRC parameters，Better give me some CRC routines.

Regards,

over 7 years ago

0 Miro over 7 years ago

TI__Mastermind 21425 points

Hello,
Please, take a look ath the following application note: www.ti.com/.../spna235.pdf

Best regards,
Miro

0 Kai Huang2 over 7 years ago in reply to Miro

Prodigy 120 points

Hi Miro,
Thank you for your response.
I've read the document, but I still don't quite understand it. In Full-CPU Mode , after check signature ,how are CRC values compared.
And if I want to observe the CRC value of the input data, how do I operate it?
Best regards,
HK

0 Miro over 7 years ago in reply to Kai Huang2

TI__Mastermind 21425 points

Hello,
Do you need more info concerning this thread?

Best regards,
Miro

0 Kai Huang2 over 7 years ago in reply to Miro

Prodigy 120 points

Hi Miro
Thank you for your response, I have solved this problem.Thanks.
Best regards,
HK

Arm-based microcontrollers

Arm-based microcontrollers forum

RM44L920: How to configure CRC program？