• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 31 subscribers
  • Views 424 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TMDSEMU110-U: How to control XDS110 GPIO pins?

Sebastian Brueckner
Intellectual 395 points
Part Number: TMDSEMU110-U


Hi,

the XDS110 website and manual mention that it has 4 GPIO pins available.

How can I control the state of these GPIO pins from the PC?

Is a command line tool (like xds110reset.exe) available? 

I couldn't see any obvious settings in the CCS target configuration that would allow setting GPIOs. maybe someone could point me in the right direction.

Best regards

Sebastian

  • 0
    TI__Guru**** 171309 points

    Sebastian,

    The GPIO is only accessible via the dbgjtag utility. At a certain point there were plans to have additional control via the GUI but that didn't yet materialize. 

    Please check section 3.2 of the XDS110 User's Guide (SPRUI94).

    Hope this helps,

    Rafael