TM4C123GH6PZ: Using a Raspberry Pi to program the controler.TM4C123GH6PZ

Tuna Bicim

Part Number: TM4C123GH6PZ
Other Parts Discussed in Thread: EK-TM4C123GXL,

Hello Everyone,

On my current project I need to program the microcontrollers from Raspberry Pi units.

My approach was to connect the JTAG pins of raspberry to the microprocessor and use OpenOCD but I couldn't find the cfg file of the microprocessor.

Is there any other way to achieve what I need to do using JTAG or any other method?

Best Regards,

Tuna Bicim

over 6 years ago

0 Bob Crosby over 6 years ago

TI__Guru 72500 points

I don't think there is any support for using the JTAG pins of a Raspberry Pi unit to program a TM4C123GH6PZ. It will be much less effort and frustrations to get an EK-TM4C123GXL launchpad. You can configure it for programming a TM4C123GH6PZ on your board through the JTAG pins.

See section 4.6: http://www.ti.com/lit/an/spma075/spma075.pdf

0 Tuna Bicim over 6 years ago in reply to Bob Crosby

Intellectual 440 points

Thanks for the answer Bob,

I saw some of the TI models on OpenOCD so I was curious to see if someone else tried to use this model with that.

I already have a TM4C123GXL. I will look into using that if I can't find anything else.

Best Regards,

Tuna Bicim

0 Bob Crosby over 6 years ago in reply to Tuna Bicim

TI__Guru 72500 points

I have to admit I am not very familiar with using OpenOCD on the TM4C, but I think what I saw was using the Stellaris ICDI connected by USB (such as the ICDI on the EK-TM4C123XL).

Arm-based microcontrollers

Arm-based microcontrollers forum

TM4C123GH6PZ: Using a Raspberry Pi to program the controler.TM4C123GH6PZ