CCS/TM4C1292NCPDT: Using a TM4C129 chip to program another TM4C129 or TM4C123 that has the flash bootloader.

Tuna Bicim

Part Number: TM4C1292NCPDT

Tool/software: Code Composer Studio

Hello Everyone,

I am using the USB Stick Host example to find and read a binary file on TM4C129.

After reading this I want to send this binary file to another chip thorugh SSI or UART.

How can I find out about the procedure to send this data over and If needed calculate the checksum etc to update the other chip.

Basically, I am trying to do what LM Flash Programmer does with a TM4C129 chip.

Thanks,

Tuna Bicim

0 Bob Crosby over 6 years ago

The documentation and the functions to do the bootloader are in the TivaWare library. The User's Guide can be found in:

C:\ti\TivaWare_C_Series-2.1.4.178\docs\SW-TM4C-BOOTLDR-UG-2.1.4.178.pdf

Section 3 describes the packet handling. The source code can be found in:

C:\ti\TivaWare_C_Series-2.1.4.178\boot_loader

0 Tuna Bicim over 6 years ago in reply to Bob Crosby

Hello Bob,

Thank you for the response.

I was just curious if there was any code example that followed the procedure on that document.

It seems I need to implement the functions to send the commands according to the packet structure.

Best Regards,

Tuna Bicim

0 Bob Crosby over 6 years ago in reply to Tuna Bicim

I have no examples for the device sending the packets. You are correct.

0 Tuna Bicim over 6 years ago in reply to Bob Crosby

I got all the packet structures, general send and receive functions from the bootloader source code.

I am implementing the command functions myself. I will reply back if I have any more questions.

Thanks again for the replies.

Arm-based microcontrollers forum