UNIFLASH: Uniflash stuck at "Connected to COM port"

user1066577

Part Number: UNIFLASH
Other Parts Discussed in Thread: IWR1642, TIDA-020004

Hi,

I Use Uniflash to program a IWR1642 board.

On my desktop computer, it'll always stuck at "Connected to COM port".

While on my laptop , uniflash can succeed to complete the programming.

Don't know why.

0 Akash Gondalia over 5 years ago

Hi User,

Would you be able to post a screen shot and a picture of your powered board when this error occurs?

Cheers,

Akash

0 user1066577 over 5 years ago in reply to Akash Gondalia

Hi Akash,

Thanks for your attention.

This is the screen shot:

The board is modified from TIDA-020004, just replace the CAN part to USB2UART chip:

0 Kyle Cousino over 5 years ago in reply to user1066577

Can you send a screen shot of your Windows Device Manager when your board is powered on and connected to your PC?

Regards,
Kyle

0 Kyle Cousino over 5 years ago in reply to Kyle Cousino

I'm still looking for a screen shot of your Windows Device Manager when your board is powered on and connected to your Desktop PC.

If there are no further responses, I will close out this thread.

Regards,
Kyle

Arm-based microcontrollers forum