TMS570LS3137: Gel file modification of uniflash windows

Mitchell

Part Number: TMS570LS3137
Other Parts Discussed in Thread: UNIFLASH, SEGGER

Hi Team,

When my customer flashes the TMS570 via Uniflash windows, the first step it executes is a "verify" and then "erase" if the two binaries are different. Is it possible to modify these steps to remove the first "verify" and make "erase" as first step ? (There is "verify" as last step already as well.)

Can you please point us to the location of gel file to modify or if it is more complicated then modifying one file can you please guide us on how to set this?

Thanks,
Mitchell

over 5 years ago

0 Ki over 5 years ago

TI__Guru**** 465171 points

Hello,

What are the customer's flash settings? And can he provide a verbose console output?

Thanks

0 Mitchell over 5 years ago in reply to Ki

TI__Expert 4915 points

Hi Kai,

I apologize, there might have been a little bit of confusion in my initial question. My customer would like to edit the gel file to remove the "compare" step.

Thanks,
Mitchell

0 Ki over 5 years ago in reply to Mitchell

TI__Guru**** 465171 points

This discussion was taken off-line. For those following this thread, the customer is using J-Link and the additional compare and verification steps is specific to J-Link and I believe they can be configured from the SEGGER J-Link Control Panel.

Thanks

Arm-based microcontrollers

Arm-based microcontrollers forum

TMS570LS3137: Gel file modification of uniflash windows