CCS/TMS570LS3137: CCS debug program error

Hello,

Please check debug configuration to make sure the Auto ECC Generation is enabled, and Auto Run from main() is also enabled. 

Is there any difference between settings in CCS debug and Uniflash?

Hi QJ，

Sorry，I can not  find “Auto ECC Generation” configuration in CCS 9.1.

Thanks very much.

Under CCS-->RUN-->debug configuration:

Please find the difference between Uniflash settings and CCS debug settings.

Hi,QJ,

Sorry,I can not find this config function  in my  ccs IDE ，I need your help，thank  you.

uniflash:

<configuration XML_version="1.2" id="configuration_0">
<instance XML_version="1.2" desc="SEGGER J-Link Emulator" href="connections/segger_j-link_connection.xml" id="SEGGER J-Link Emulator" xml="segger_j-link_connection.xml" xmlpath="connections"/>
<connection XML_version="1.2" id="SEGGER J-Link Emulator">

CCS:

<configuration XML_version="1.2" id="Segger J-Link Emulator_0">
<instance XML_version="1.2" desc="Segger J-Link Emulator_0" href="connections/segger_j-link_connection.xml" id="Segger J-Link Emulator_0" xml="segger_j-link_connection.xml" xmlpath="connections"/>
<connection XML_version="1.2" desc="Segger J-Link Emulator_0" id="Segger J-Link Emulator_0">

CCS-->Tools-->On-Chip Flash

You can dump the flash content to files and check any difference between CCS flash content and uniflash flash content.

BTW, the main flash starting at 0x00000000

The flash ECC is located at 0xF0400000