TMDSCNCD28388D: Stop with Ethernet_resetModule in lwip

Tsuchiya-San,

I will ask someone to look into this, do you have anymore information on what issue occurred?

Regards,
Cody 

cody,

Currently, we are using cm_common_config_c28x to check the operation of enet_lwip.
The Ethernet_initInterface function of the driver is executed in the Ethernet_init function executed by the main function in enet_lwip.c.
A loop occurred in the Ethernet_ResetModule in it, and it is impossible to continue processing.
I've attached a picture of the debug state below.

Additional note: I found a thread about a similar issue within the C2000 forums.
thread URL:https://e2e.ti.com/support/microcontrollers/c2000-microcontrollers-group/c2000/f/c2000-microcontrollers-forum/914434/tms320f28388d-c2000ware-ethernet-driver-initialization
This thread mentions that the Ethernet_resetModule stops working due to a problem with the peripheral's clock.
There is no detailed information about the board in that thread.
However, this time we will be checking the operation on the evaluation board, so we believe that clock problems are unlikely to occur.

thank you.

Hi,

The subject matter expert is out of office today, please expect response by tomorrow.

Thanks & Regards,

Santosh