TMS320F280048-Q1: Debug stops at ESTOP0 line in device.c

Gokhan G.

Part Number: TMS320F280048-Q1
Other Parts Discussed in Thread: C2000WARE

Hi,

I cannot debug my code because the code stops at ESTOP line in device.c

My code builds very well.

I'm using the reference code from the folder below;

C:\C2000Ware_4_02_00_00\training\device\f28004x\getting_started\lab_blinkyled_driverlib

How can I resolve the issue? Why does the debug stops at this line?

I showed it as below;

0 Ryan Ma over 1 year ago

Hi Gokhan,

Could you screenshot what ASSERT the code fails at before it gets to the __error__ function call?

I will see if I can replicate what you're seeing in the mean time.

Best,

Ryan Ma

0 Gokhan G. over 1 year ago in reply to Ryan Ma

Hi Ryan,

I push debug button and then play. Then the code halted at ESTOP line.

Which part do you require? What do you need?

By the way, code was RAM based and I changed the build option from RAM to FLASH by using setting FLASH active.

0 Gokhan G. over 1 year ago in reply to Gokhan G.

Hi,

I added some ss as below. I think it get error at below line;

" GPIO_setAnalogMode(0, GPIO_ANALOG_DISABLED);"

First one is the first stop and other continuous after I pushing the STEP RETURN button.

0 Ryan Ma over 1 year ago in reply to Gokhan G.

Hi Gokhan,

I will forward this to a GPIO expert to further assist you.

Best,

Ryan Ma

0 Vince over 1 year ago in reply to Ryan Ma

Hi Gokhan,

You are trying to set pins that are not Analog Mode capable (they don't need to set analog mode):

    //
    // Check the arguments.
    //
    ASSERT(((pin >= 224U) && (pin <= 247U)) || (pin == 22) || (pin == 23));

Regards,

Vince

C2000 microcontrollers forum