F2812 FLASH

Thiyagarajan . S

Other Parts Discussed in Thread: TMS320F2812

hi,

am using tms320f2812 kit, am doing some projects in SCI BOOT mode. , am programming my flash through SCI ( rs 232 cable). my target is connecting & erasing but it's not progrmming????,,, i think that my power supply is not having sufficient current (amp)........ so i want to know the data for flash programming current rate ???

1. what is minimum current required to program flash ?

Note: am using 5v / 1amp adapter.

over 13 years ago

0 Vaishnavi Ramachandran over 13 years ago

TI__Intellectual 1950 points

This is being discussed in the other post : http://e2e.ti.com/support/microcontrollers/tms320c2000_32-bit_real-time_mcus/f/171/t/185102.aspx

0 Oscar Baumann over 13 years ago in reply to Vaishnavi Ramachandran

Intellectual 835 points

Hi, I have one question I want to know if i can program flash. Using sdflash and send the signales by usb port.

Using ft232 to interface usb/sci-a.

Instead of to use rs232-sci-a interface.

Thanks

0 BrandonAzbell over 13 years ago in reply to Oscar Baumann

TI__Guru 64600 points

Oscar Baumann said:

Hi, I have one question I want to know if i can program flash. Using sdflash and send the signales by usb port.

Using ft232 to interface usb/sci-a.

Instead of to use rs232-sci-a interface.

This certainly should be possible.

C2000™︎ microcontrollers

C2000 microcontrollers forum

F2812 FLASH