Unable to run the F28035 PMSM code from Flash

Hi,

I noticed that a breakpoint was active, did you try after removing the same? Also, you switched to Flash configuration from Build Configuration -> Set Active right? or any other way?

Regards,
Gautam

Dear Mr.Gautham,
I have not given any breakpoint in the code. The PMSM code taken from controlsuit is used. It works fine in RAM mode.
There are no configurations settings - Flash or RAM.
I followed the instructions given by Sean Bigly and added the necessary files to move the code to run from flash. The code is flashed successfully without any problem.
Please review and suggest.
thx
KV

K.V. Rao said:

I have not given any breakpoint in the code.

Your screenshot indicates that the code is paused at a breakpoint.

Dear Mr.Gautham,

Thanks for your input.  I have reloaded the code and it works fine now.  There is no break point indication however the Isrticker is still not active.  Could you please suggest how to sort this.

Attached the PPT this might help. 

I wander what could be the reason.  Same code runs fine in RAM (checked it again).  Is there any other settings I missed?. Please suggest.

thx

KVRao0841.PMSM_flash.pptx

Dear Mr.Gautam,

Could I request your attention please.

thx

Hi All,

Could anyone help me resolve the issue of Isrticker not active when I move the code to FLASH.  However the code runs fine in RAM mode.

thx

KV

Dear Mr.Gautham,

Could you please review and suggest.

thx

KVRao

Dear Mr.Gautham,


Could you please review and suggest.


thx

KVRao