Simulink code composer interfacing

Maxime Tesson

Prodigy 30 points

While trying to blink the leds from Simulink,I get the following error message.

Error(s) encountered while building "led": ### Failed to generate all binary outputs.

I would greatly appreciate any help to address this problem

over 8 years ago

0 Gautam Iyer over 8 years ago

Guru 192875 points

Hi Maxime,

Please check whether the C2000 compiler is well integrated with simulink. Please refer this link to get started:
e2e.ti.com/.../484814

Regards,
Gautam

0 Brian McKay over 8 years ago

Mastermind 9005 points

Hi Maxine,

What version of MathWorks tools and CCS are you using?

-Brian

0 Maxime Tesson over 8 years ago in reply to Brian McKay

Prodigy 30 points

Hi Brian
I using Matlab 2016a and CCS 6

0 Maxime Tesson over 8 years ago in reply to Gautam Iyer

Prodigy 30 points

Hi Gautam
I tried but the problem still I have the problem

0 Brian McKay over 8 years ago in reply to Maxime Tesson

Mastermind 9005 points

Hi Maxine,

That combo should be fine. I cant tell from the info you posted what is wrong. Did you get one of the example models to work?

If you want to try walkthrough through the setup again, type targetupdater at the MATLAB command line

You may also wish to contact MathWorks Technical Support for specific help; they may have additional suggestions for you.

Cheers,

-Brian

C2000™︎ microcontrollers

C2000 microcontrollers forum

Simulink code composer interfacing