CCS/TMS320F28379D: Standalone Blinky code not working

Hi Sagar,

Did you change the configuration to flash? Project -> Build Configurations -> Set Active -> Flash

Regards,
Gautam

  

This works. But is there a location where I can find the configuration file as shown in the image?

In my project I cannot find this standalone file. IS there a way to add to my project? 

Thanks.

Any suggestions?

Sagar, this is part of the project setting. If you have taken one of example code and develop your code using that as base project then it should be there. If not then you need to create these configuration and include different linker cmd file for different configuration.

Regards,

Vivek Singh

I did not use the example code as base project. Can you help find the linked files?

The previous post is my question and not solution. PLS read the comment completely Vivek.
Can someone assist the steps to make it on standby without using blinky as base project?

Hi Sagar,

Check this out: e2e.ti.com/.../590485

Regards,
Gautam