TMS320F2812: Why while programming flash memory of TMS320F2812 by uniflash and XDS110 debug probe giving error?

Mahendra Rana

Part Number: TMS320F2812
Other Parts Discussed in Thread: UNIFLASH,

Can any one help that why this error comes while programming flash of TMS320F2812 by uniflash and XDS110 debug probe and how to resolve it: -

After I tried to update firmware xdsdfu-e exe but it gives errror as found 0 devices even though in device manager of system XDS110 detected. So How I can resolves this issues?

over 6 years ago

0 desouza over 6 years ago

TI__Guru**** 169864 points

Hi,

The error -260 is covered in detail in the Debugging JTAG page below: (search for the error number)

http://software-dl.ti.com/ccs/esd/documents/ccs_debugging_jtag_connectivity_issues.html

That said, the root cause for the debug probe not being accessible may be due to it being locked by another application. In other words, make sure that CCS and Uniflash are not running at the same time (it seems you have both installed) and, if this is the case, try to unplug and re-plug the Debug Probe (or even plug to a different USB port), since a process may be hijacking your XDS110 and consequently preventing it from being visible by another application.

Hope this helps,

Rafael

0 Mahendra Rana over 6 years ago in reply to desouza

Expert 1010 points

Dear Rafael,

Thank you for your reply and comments!

I will check and updates you for same.

Regards,

Mahendra

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F2812: Why while programming flash memory of TMS320F2812 by uniflash and XDS110 debug probe giving error?