TMS320F28069: i2c connection between eeprom

supun dassanayake

Prodigy 20 points

Part Number: TMS320F28069
Other Parts Discussed in Thread: CONTROLSUITE

i am struggling to connect eeprom with c2000.

can you help me with that.

i am using a sample cord which in the control sute. called i2c eeprom.

and also i change gpio pins to 33 and 32.

over 6 years ago

0 Kevin Allen18 over 6 years ago

TI__Mastermind 45606 points

Hi Supun,

Are you having hardware setup or software issues? Can you provide the part number of the eeprom you're using?

You may need to refer to your eeprom's datasheet and make your code correspond with the expected protocol. The example in ControlSuite may not work with your eeprom by default.

Best,

Kevin

0 supun dassanayake over 6 years ago in reply to Kevin Allen18

Prodigy 20 points

i am using 1K i2c 400KHZ eeprom (24AA01-I/MS-ND)

0 Kevin Allen18 over 6 years ago in reply to supun dassanayake

TI__Mastermind 45606 points

Hi Supun,

The i2c_eeprom example will need to be edited to match the expected protocol of that eeprom. The example sends two memory addresses (High and Low) while your eeprom only needs one address.

You can check out the code in the below E2E, it is likely easier to understand and edit:

https://e2e.ti.com/support/microcontrollers/c2000/f/171/t/773846

Please check your HW config as well. You'll need to use external pull-up resistors that can meet 400 KHz speeds.

Best,

Kevin

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28069: i2c connection between eeprom