TMDSCNCD28388D: C2000 ETHERNET

@vince

Part Number: TMDSCNCD28388D
Other Parts Discussed in Thread: C2000WARE

If we want to adjust the ethernet port on this card, is there a routine corresponding to CPU1 in our C2000 ware, which can send data out through the ethernet port and display the data on the laptop？

thanks！

over 4 years ago

0 Yashwant Temburu1 over 4 years ago

TI__Expert 4145 points

Hi Vince,

There are 3 ports on the f28388d control card but out of these 2 (J5,J6) are for EtherCAT and the other (J4) is for Ethernet. It is not possible to use the other ports for ethernet as they don't support pin mux for the same.

Though there are other pin mux options possible for Ethernet pins you would have to spin out a custom board.

Regards,

Yashwant

0 @vince over 4 years ago in reply to Yashwant Temburu1

Intellectual 651 points

Hello，Yashwant Temburu

I may not express it clearly. What I mean is, I want to connect the J4 port (ethernet) to the computer through a network cable. The data can be sent to the computer through the J4 port.

If you want to achieve such a process, is there a most suitable routine in C2000ware?

thanks!

Greetings

vince

0 @vince over 4 years ago in reply to Yashwant Temburu1

Intellectual 651 points

Routine, preferably CPU1 core. I haven't started using the CM core here. It may be used, but not very good at using it.

0 Yashwant Temburu1 over 4 years ago

TI__Expert 4145 points

Please go through this thread e2e.ti.com/.../tms320f28388d-c2000-microcontrollers-forum and see if it helps.

0 @vince over 4 years ago in reply to Yashwant Temburu1

Intellectual 651 points

thanks

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMDSCNCD28388D: C2000 ETHERNET