EVM430FR6043-Sensing

Karthikeyan S

Other Parts Discussed in Thread: EVM430-FR6043, TIDM-02005

Hi,

1.Will EVM430-FR6043 be used to measure both gas and water flow?

2.How to give 1000kHz transmitting frequency in the ultrasonic sensing design center?

3.Is there any method to find the voltage being used by the sensors in the software itself?

0 Dennis Lehman over 4 years ago

Hi Karthikeyan,

Let me reach out to our USS experts to get you an answer.

0 Dennis Lehman over 4 years ago in reply to Dennis Lehman

Hi Karthikeyan,

I'm still waiting for answers on #1 and #3, but for #2, you set the transmit frequency in the GUI as shown below.

0 Dennis Lehman over 4 years ago in reply to Dennis Lehman

Hi Karthikeyan,

Regarding #1 : TIDM-02005 describes hardware changes needed for water. Default hardware configuration is for gas.

Regarding #2: No.

0 Karthikeyan S over 4 years ago in reply to Dennis Lehman

Hi Dennis Lehman,

I will surely change the default hardware configuration.

Thank you

**Attention** This is a public forum

MSP low-power microcontroller forum