MSP-GANG: How read current image number through RS232?

Edgaras Kucinskas

Part Number: MSP-GANG

In my GANG is 4 different images with different SW for MSP430FR68976. I have conected RS232 cable to GANG and communicate. With 3E 31 4 4 0 0 0 0 C5 CA telegram I can start programming and with A5 get GANG status. But I can't change image in GANG and get current image number or name through RS232.

over 5 years ago

0 Eddie LaCost over 5 years ago

TI__Mastermind 47635 points

Hello Edgaras,

I am looking into this and will let you know what I can find.

0 Gregory Czajkowski over 5 years ago

Expert 2200 points

Hi,

Look into MSP-GANG manual - page 65:
Get Image Header and Select Image commands.

Let me know if you have any questions.

Regards,
Gregory Czajkowski
Elprotronic Inc.

0 Edgaras Kucinskas over 5 years ago in reply to Gregory Czajkowski

Prodigy 30 points

Hellow Gregory,
Thank You for You answer.
I am using 'SLAU358D' pdf. In page 65 is '4.1 Gang430.dll Wrapper Description'.

In commands table i was found:
3.5.4.8 Read Image Header Command
Tx -> 3E 47 6 6 A1 A2 0 0 n 0 CKL CKH
Rx -> 80 0 n n D1 ... Dn CKL CKH
NOTE: Do not use this command. This command is used by the API-DLL and GUI only.
(SLAU358D.pdf' page 62)
About 'Read Image Header' no more information :(.
Maybe You can send me telegram example?
( 'Select Image' command work fine, thank You :) )
Thank You in advance

Edgaras

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP-GANG: How read current image number through RS232?