MSP430G2452: Firmware for energytrace

BIDAULT Hoel

Part Number: MSP430G2452
Other Parts Discussed in Thread: ENERGYTRACE,

Hello,

I am currently working on a MSP430 ULP design and i integrated the energytrace circuit into our "dev" board.

The dev board contains the ULP design along with an "instrumentation" MCU and the energytrace circuitdirectly taken from the esp432 documents.
Where can we get the MSP430G2452 firmware, either in binary or to compile by ourself?

Thank you.

over 2 years ago

+1 zrno soli over 2 years ago

Guru 33653 points

Binary compatible with DLL (on PC side) can be found inside DLL source (as C constant hex byte array). Source is in FetDcDcController IAR project (in options MSP430G2452 is selected as target device) that can be compiled/builded, of course. All of this is in slac460 open source MSP Debug Stack.

0 BIDAULT Hoel over 2 years ago in reply to zrno soli

Intellectual 320 points

Oh, thank you, very nice indeed, there is a lot of things here. Regarding the FetDcDcController IAR project, where did you find it? i could not locate it inside MSPDebugStack directory

0 BIDAULT Hoel over 2 years ago in reply to BIDAULT Hoel

Intellectual 320 points

nevermind, it was on level upper, got it now.

+1 zrno soli over 2 years ago in reply to BIDAULT Hoel

Guru 33653 points

Open IAR Workspace "\Bios\eZ-FET_Bios.eww" and last project on list is one that you need.

Don't know if and what you will use on PC side. All TI PC tools are going over same DLL and will complain if your binary will be different than one stored inside DLL.

0 BIDAULT Hoel over 2 years ago in reply to zrno soli

Intellectual 320 points

the idea is to use it standalone driven by the instrumentation MCU

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430G2452: Firmware for energytrace