How to program the msp430g2452 microcontroller using eZ430-F2013

ANDRES RADA

Other Parts Discussed in Thread: MSP430G2452

Hello there,

I would like to know how to program the msp430g2452 microcontroller using eZ430-F2013? I tried to use the GUI-based utility for LaunchPad without any success.

I will appreciate any comments or suggestions.

Thanks,

Andres Rada.

over 15 years ago

0 Joerg Quinten over 15 years ago

Guru 17650 points

Hi Andres,

the firmware of the eZ430-F2013 doesn't support the MSP430G2452. It only supports: MSP430F200x, 'F201x, 'G2x01, 'G2x11, 'G2x21, and 'G2x31

You should buy a Launchpad (since it support programming/debuging a lot of other MSP430 devices too.

Kind regards
aBUGSworstnightmare

0 ANDRES RADA over 15 years ago in reply to Joerg Quinten

Prodigy 235 points

Dear aBUGSworstnightmare,

Thanks for your reply. You're right.

Best regards,

Andres Rada.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

How to program the msp430g2452 microcontroller using eZ430-F2013