MSP430FR2533: Schematic and PCB pattern review

Kazuya Nakai59

Guru 22355 points

Part Number: MSP430FR2533

Hi team,

Please check the schematic and PCB pattern.

The pattern diagram has the following requirements

Overlay will be 3mm ABS plastic.

Sensor pattern will be 10x10mm.

Sensor spacing will be 22mm.

Your reply would be much appreciated.

Best regards,
Kazuya.

0 Eason Zhou over 3 years ago

For schematic, as I check, it is OK. No obvious error.

I think you have do a very good PCB layout! Make the TX and RX to accorss only at the button.

0 Kazuya Nakai59 over 3 years ago in reply to Eason Zhou

Guru 22355 points

Hi Eason,

Thank you for your reply.
Your checking is very helpful for us.

Thank you gain and best regards,
Kazuya.

**Attention** This is a public forum

MSP low-power microcontroller forum