MSP430F5529: MSP430f5529 usb interface

Tex

Intellectual 330 points

Part Number: MSP430F5529

Hi forum,

i would like to do MSP430f5529 usb interface to control gpio without the eZ-FET lite emulator

and upload the code with the help of bootloader

please suggest me how can i do that with my existing F5529 launchpad

Best regards,

Tex

over 2 years ago

+1 zrno soli over 2 years ago

Guru 34813 points

Inside USB Developer Package there are USB examples that are by default configured for 5529 wit 4 MHz XT2 (5529 LP target device).

www.ti.com/.../MSP430USBDEVPACK

0 Tex over 2 years ago in reply to zrno soli

Intellectual 330 points

thanks for your valuable reply sir,

could you please tell me what are all the hardware changes need to do in my launch pad

i just did few basic programs using CCS but don't know how to do when it comes to usb interfacing,

since i have less knowledge in msp430f5529 usb interface, i wonder if i can get any tutorial to achieve this

i will greatly appreciate your valuable suggestions

Best regards,

Tex

+1 zrno soli over 2 years ago in reply to Tex

Guru 34813 points

There is no need for any hardware changes. Target device on 5529 LP is prepared for USB. Just download any USB example and it should work. There are also basic CDC/HID binaries prepared for 5529 that can be downloaded by TI HID BSL and USB Firmware Upgrade Example Win GUI on PC side...

0 Tex over 2 years ago in reply to zrno soli

Intellectual 330 points

Thanks for your valuable info

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP430F5529: MSP430f5529 usb interface